Ic-7000 cam user’s guide – Edimax Technology Pan/Tilt IP Surveillance Camera IC-7000 User Manual
Page 37
`
IC-7000 CAM User’s Guide
P
P
a
a
n
n
/
/
T
T
i
i
l
l
t
t
I
I
P
P
S
S
u
u
r
r
v
v
e
e
i
i
l
l
l
l
a
a
n
n
c
c
e
e
C
C
a
a
m
m
e
e
r
r
a
a
IC-7000 USER’S GUIDE
PAGE 37/62 Rev.
PV1.0
- In 160x120 resolution, the motion detection is fixed to the entire image.
Note:
1. Motion detection can exist PC and SD Card **
2.
Image will be stored to ‘C: \tmp\webmd’ directory.
4.5 M
OTOR
C
ONTROL
1.
— Home , return to the middle place.
2.
— Up, press it to move camera up.
3.
— Down , press it to move camera down.
4.
— Left, press it to move camera left.
5.
— Right , press it to move camera right.
6.
— Auto , after press this bottom, camera will pan between left and right automatically.
5.
A
DVANCED
A
PPLICATION
This section describes the advanced settings of the IC-7000 IP-CAM, including:
- Image Setup
- Capture View
- Network Setup
- Server Setup
- Event Trigger Setup
- Administration Setup
- Software Update
5.1 I
MAGE
S
ETUP
This includes:
- Resolution:Users can select between image resolution of 160x120, 320x240, and
640x480. The default resolution is 320x240.
- Quality: Users can select between “fine”, “normal”, and “basic” image quality. The
default image quality is “basic”.
- Anti-Flicker:Users can select between 60Hz for USA and Canada, 50Hz for Australia
and Europe, or Outdoor for when you are using this camera in an environment without
artificial light; The default setting is 50Hz.
- Audio:Audio output. Default setting is “off”.
- Rotate 180: This setting turns the image upside-down for when the camera is mounted
to a ceiling; Default setting is “off”.
- IR Auto Detection:IR LED will be activated automatically when there’s no enough light.
Default setting is “on”
- Message: LiveView characters are hidden，
Default setting is “on”**
Instructions for image setup:
Step 1. Click
to enter imageset menu, the default settings are shown