Kichler 300006 - Manual (Page 9)

8 Wilton
TM
9. ATTACHING THE FAN BLADES
Fig. 16
Fig. 18
Fig. 17
10. INSTALLATING THE MOUNTING PLATE
Step 1 Attach the blade to the blade bracket
using the screws, washers and fiber washers
as shown in Figure 16. Start screw into
bracket. Repeat for the three remaining screws.
Step 2. Make sure the blade is straight and
tighten each screw.
Step 3. Fasten blade assembly to motor using
"pre-installed" mounting screws in the blade
bracket . (Fig. 17)
Blade
Blade bracket
Mounting plate
Mounting ring
Screw
Blade bracket
Screw
Silicon washer
Blade
Metal washer
Step 1. Remove 1 of the 3 screws in the
mounting ring and loosen the other 2 screws.
(Do not remove)
Step 2. Place the key holes on the mounting
plate over the 2 screws previously loosened
and turn the mounting plate until it locks in
place at the narrow section of the key holes.
Secure by tightening the 2 screws previously
loosened and reinstall the one removed.
(Fig. 18)
NOTE: If you would like to install the light
fixture that came with your ceiling fan, please
skip to Step 12 and continue. If you want you
ceiling fan installed WITHOUT the light
fixturek, follow Step 11 and then skip to Step
14.