Kichler 300006 - Manual (Page 8)

7
Fig. 14
Fig. 15
Step 1. Tuck connections neatly into ceiling
outlet box.
NOTE: adjust the canopy screws as necessary
until the canopy and canopy cover are snug.
(Fig.15)
Note: Fan must be installed at a maximum
distance of 30 feet from the transmitting unit for
proper signal transmission between the
transmitting unit and the fan's receiving unit.
8. INSTALLING THE CEILING CANOPY
Step 2. Slide the canopy up to ceiling and
onto the two screws on hanger bracket.
Rotate the canopy clockwise and tighten both
screws.
Step 3. Remote Receiver to Outlet Box Electri-
cal Connections: Connect the black (hot) wire
from the ceiling to the black wire marked “AC in
L” from the receiver.
Connect the white (neutral) wire from the ceil-
ing to the white wire marked “AC in N” from the
Receiver. Secure the wire connections with the
plastic wire nuts provided. (Fig. 14)
Step 4. If your outlet box has a ground wire
(green or bare copper) connect it to the fan
ground wires; otherwise connect the hanging
bracket ground wire to the mounting bracket.
Secure the wire connection with a plastic nut
provided. After connecting the wires, spread
them apart so that the green and white wires
are on one side of the outlet box and black
and blue wires are on the other side.
Carefully tuck the wire connections up into
the outlet box. (Fig. 14)
Warning: Make sure the “Check Tab” at the
bottom of the hanger bracket is properly seated
in the “Registration Slot” on the side of the
hanger ball before attaching the canopy to the
bracket. Failure to properly seat the“Check Tab”
could damage the electrical wires when to ceiling
fan blade direction is changed while the fan is
running.
CAUTION: All set screws must be checked and
retightened where necessary.
Outlet box
Hanger bracket
Screw
Canopy ring
Blue (for bottom light)
(green) ground wire on
White("AC IN N")
Ground -(Connect to
White("to motor N")
Copper (ground)
Green or bare
White (neutral)
Black (motor)
Orange
(For upper light)
Blue (for ring light)
Black ("to motor L")
Receiver
Black("AC" IN L")
Black (hot)
Outlex box
white (neutral)
wire exists)
hanger bracket
if no house ground
white (neutral)
Orange
(For upper light)
Canopy