Kichler 300006 - Manual (Page 6)

5
Fig. 10
Registration slot
Step 6. Slip the coupling cover, canopy cover
and canopy onto the downrod. Carefully
reinstall the hanger ball onto the downrod.
Make sure the cross pin is in the correct
position and the set screws are tight and the
wires are not twisted. (Fig 9)
Step 7. Now lift the motor assembly into
position and place the hanger ball into the
hanger bracket. Rotate until the “Check Tab”
has dropped into the “Registration Slot” and
seats firmly. (Fig. 10) The entire motor
assembly should not rotate if this is done
correctly.
Fig. 9
Supply wires
Canopy
Coupling cover
Hitch pin
Lock pin
Canopy cover