Kichler 300004 v.2 - Manual (Page 9)

8 Meredith
TM
9. ATTACHING THE FAN BLADES
Fig. 16
Fig. 17
Fig. 18
10. INSTALLATING THE MOUNTING PLATE
Step 1 Attach the blade to the blade bracket
using the screws, washers and fiber washers
as shown in Figure 16. Start screw into
bracket. Repeat for the two remaining screws.
Step 2. Make sure the blade is straight and
tighten each screw.
Step 3. Fasten blade assembly to motor using
"pre-installed" mounting screws in the blade
bracket . (Fig. 17)
Blade bracket
Screw
Blade
Fiber washer
Metal washer
Blade bracket
Screw
Connection plug
Mounting plate
Step 2. Place the key holes on the mounting
place over the remaining 2 screws on the
mounting ring, turn mounting plate until it locks
in place at the narrow section of the key holes.
Secure by tightening 2 screws and reinstalling
the third screw. (Fig. 17)
Note: If you would like to install the light fixture
that come with your ceiling fan, please skip to
step 12 and continue. If you want your ceiling
fan installeed without the light fixture, follow
step 11 and then skip to Step 14.
Step 1. Remove 1 of the 3 screws on the
mounting ring and loosen the other 2 screws.
(Do not remove)