Kichler 300004 v.2 - Manual (Page 5)

4 Meredith
TM
5. HANGING THE FAN
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
Step 2. Secure the hanger bracket to the
ceiling outlet box using screws and washers
provided. (Fig. 6)
Step 3. Remove hanger ball from downrod
assembly by loosening set screws, removing
the cross pin, and sliding ball off the rod. (Fig. 7)
Step 4. Loosen the two set screws and
remove the hitch pin and lock pin from the top
coupling of the motor assembly. (Fig. 8)
Step 1. Remove the fan motor and housing
assembly from the protective plastic bag.
Place the fan assembly into the lower pad
with the bottom of the motor facing up.(The
lower foam pad serves as a holder for the
fan during the first stages of assembly).
Remove the plastic motor shipping blocks
and discard. (Fig. 5)
Step 5. Carefully feed fan wires up through
the downrod. Thread the downrod onto the
motor coupling until the hitch pin holes are
aligned. Next, replace hitch pin and lock pin,
and tighten both set screws. (Fig. 8)
Fig. 7
Fig. 5
Fig. 6
Fig. 8
Downrod
Cross pin
Hanger
ball
Set screw
shipping block
Screw
Fan housing
Downrod
Lock pin
Hitch pin
Mounting bracket
CUL listed electrial box
Mounting screw
120V wires
Washer