Meredith – Kichler 300004 v.2 User Manual

Page 7

Meredith

6. INSTALLATION OF SAFETY SUPPORT
( For Canadian Installation ONLY )

Fig. 11

Fig. 12

Fig. 13

An additional safety support is provided to
prevent the fan from falling. Secure the safety
cable to the ceiling joist with screw and
washer, as illustrated in Figure 11.

7. MAKE THE ELECTRIC CONNECTIONS

WARNING: To avoid possible electrical
shock, be sure electricity is turned off at the
main fuse box before wiring.

Code switch

Receiver

Hanger
bracket

Battery Compartment

NOTE: The CoolTouch

Control System is

equipped with 16 code combinations to
prevent possible interference from or to other
remote units. The frequency switches on your
receiver and transmitter have been preset at
the factory. Please recheck to make sure the
switches on the transmitter and receiver are
set to the same position, any combination of
settings will operate the fan as long as the
transmitter and receiver are set to the same
position. (Fig. 12)

Hanger bracket

Safety cable

Step 2. Motor to Receiver Electrical Connec-
tions: Connect the black wire from the fan to
black wire marked "TO MOTOR L" from the
receiver. Connect the white wire from the
fan to the white wire marked "TO MOTOR N"
from the receiver. Connect the blue wire from
the fan to the blue wire marked "For Bottom
Light" from the receiver. Place a plastic wire
nut on the end of the Orange Wire coming
from the receiver marked “For Upper Light”.
Your ceiling fan is not equipped with a Upper
Light. Secure all the wire connections with the
plastic wire nuts provided. (Fig. 14 on next
page)

Step 1. Insert the receiver into the mounting
bracket, and keep flat in opposition of ceiling.
(Fig. 13)