Kichler 300004 v.1 - Manual (Page 9)

8 Meredith
TM
9. ATTACHING THE FAN BLADES
Fig. 16
Fig. 17
Fig. 18
10. INSTALLATING THE MOUNTING PLATE
Step 1 Attach the blade to the blade bracket
using the screws, washers and fiber washers
as shown in Figure 16. Start screw into
bracket. Repeat for the two remaining screws.
Step 2. Make sure the blade is straight and
tighten each screw until the fiber washer is
slightly compressed and all three screws are
secure.
Step 3. Fasten blade assembly to motor using
"pre-installed" mounting screws in the blade
bracket . (Fig. 17)
Step 2. Place the key holes on the mounting
place over the remaining 2 screws on the
mounting ring, turn mounting plate until it locks
in place at the narrow section of the key holes.
Secure by tightening 2 screws and reinstalling
the third screw. (Fig. 17)
NOTE: If you would like to install the light
fixture that come with your ceiling fan, please
skip to step 12 and continue. If you want your
ceiling fan installed without the light fixture,
follow step 11 and then skip to Step 14.
Step 1. Remove 1 of the 3 screws on the
mounting ring and loosen the other 2 screws.
Blade bracket
Screw
Connection plug
Mounting plate
Metal washer
Screw
Silicon washer
Blade
Blade bracket
Do not remove the mounting ring located on
the motor shaft.