Kichler 300004 v.1 - Manual (Page 6)

5
Fig. 10
Registration slot
Step 7. Now lift the motor assembly into
position and place the hanger ball into the
hanger bracket. Rotate until the “Check Tab”
has dropped into the “Registration Slot” and
seats firmly. (Fig. 10) The entire motor
assembly should not rotate if this is done
correctly.
Step 6. Slip the coupling cover, decorative
arm, canopy cover and canopy onto the
downrod. Reinstall the hanger ball onto the
downrod and make sure the cross pin is in
place and the set screw on hanger ball is
tight. Secure the decorative arm assemble
(with the lower ends resting on the top of
the ceiling fan) by tightening the set screw.
(Fig. 9)
NOTE: The entire motor assembly should
not rotate if this is done correctly.
NOTE: Please make sure all set screws
are in place and tight before installation
the following steps.
Fig. 9
Set screw
Canopy cover
Downrod
Canopy
Decorative arm
Coupling cover