Kichler 300004 v.1 - Manual (Page 5)

4 Meredith
TM
5. HANGING THE FAN
REMEMBER to turn off the power. Follow the
steps below to hang your fan properly:
Step 2. Secure the mounting bracket to the
ceiling outlet box using screws and washers
provided with the outlet box. (Fig. 6)
Step 4. Loosen the two set screws and
remove the hitch pin and lock pin from
the motor coupling assembly. (Fig. 8)
Step 1. Remove the fan motor and housing
assembly from the protective plastic bag and
take the lower styrofoam packing pad out of
the carton. Place the styrofoam pad on the
floor, then place the fan assembly into the
styrofoam pad with the bottom of the motor
facing up. (The styrofoam pad serves as a
holder for the fan during the first stages of
assembly). Remove the plastic motor shipping
blocks and discard. (Fig. 5)
Step 3. Use a screwdriver to loosen the
cross pin and remove it from downrod
assembly. Loosen the set screw and rotate
the hanger ball off the downrod. (Fig. 7)
Step 5. Carefully feed fan electrical wires up
through the downrod. Thread the downrod
onto the motor coupling until the hitch pin
holes are aligned. Next, replace hitch pin and
lock pin, and tighten both set screws. (Fig. 8)
Fig. 7
Fig. 5
Fig. 6
Fig. 8
shipping block
Screw
Fan housing
Mounting bracket
CUL listed electrial box
Mounting screw
120V wires
Washer
Set screw
Downrod
Hanger Ball
Cross Pin
Set Screw
Hitch pin
Lock pin
Downrod