Kichler 300004 v.1 - Manual (Page 10)

9
Fig. 20
Fig. 19
12. INSTALLING THE LIGHT KIT
11. INSTALLING THE SWITCH HOUSING
Mounting plate
Connection plug
Switch housing
Switch housing
Plastic nut
White wire
Black wire
Isolation plate
Nut
Lock washer
Metal washer
Capacitor
Reverse
module
Limiter
LIGH T/ BL AC K
Pow er Li mi t
Ma x.1 90 W (O N/ OF F)
Inc an de sc en t o r Ba lla st
AC IN L /R ED AC IN N /W HIT E Mo de l No : PL -1 90 B AC 12 0V 60 HZ
NOTE: Before continuing, make sure the power
is disconnected by turning off the circuit breaker
Step 1. Loosen the 3 screws on the switch
house mounting plate.
Step 2. The square plastic wiring connector
from the ceiling fan and the light fixture will only
fit together one way. Match up the color on the
side of the connector, then push them together
until the snap engages.
Step 3. Tuck the connections neatly into the
switch housing. Align the key holes on the
switch housing with the screws on the mounting
plate. Turn the switch housing until it locks in
place at the narrow end of the key holes.
Tighten all 3 screws previously loosened.
(Fig. 19)
Step 1. Remove the finial NUT located in the
center of the switch housing. See Fig. 20.
Step 2. Remove the lock washer, metal washer
and hex nut from the light fixture mounting
stem.
Step 3. Feed the electrical wires from the light
fixture through the hole in the switch housing
(starting with the black wire first, it has a larger
switch housing, add the metal washer, lock
washer and hex nut on the inside of the switch
housing and tighten securely.
NOTE: Please take the reverse module, capaci-
tor and 190w power limiter out of the switch
housing prior to threading the light kit to switch
housing.
or removing the fuse at the circuit box.
connector). Thread the light kit onto the