Extron electronic HSA 822 - Manual (Page 25)

Packaging for Shipment
HSA 822 Hideaway ® Enclosure • Packaging for Shipment HSA 822 Hideaway ® Enclosure • Packaging for Shipment
The HSA 822’s ultra-fine machined surfaces and moving parts
make them vulnerable to damage caused by mishandling
during shipment if they are improperly packaged. If, for any
reason, you need to return an HSA to Extron, first contact
Extron to obtain a return kit. The return kit, which reduces the
chances of damage during shipment, includes a sturdy shipping
carton and foam cut to fit the HSA (figure B-1).
Figure B-1 — HSA 822 return kit
Package an HSA for shipment as follows:
1 . Contact the Extron S 3 Sales & Technical Support Hotline to
obtain a return kit. Extron will send the repair kit to the
location you specify.
The flanged edges of the top of the surface enclosure
are sharp when the HSA is removed from the table.
Exercise caution when handling to prevent personal
injury.
CAUTION The flanged edges of the top of the surface enclosure
are bevelled to an ultra-fine thickness of less than
0.04 (4/100)" (approximately 1 mm). These edges
are soft and can be easily nicked or bent. Exercise
caution when handling and mounting the
enclosure. Mishandling can damage the appearance
of the enclosure.
B-3 B-2
2 . Disconnect all cables, remove any AAPs, and remove the
HSA 822 from the table or desk. See “Removing and
Replacing the Enclosure”, steps 1 through 8, in chapter 3,
“Maintenance and Modifications”. Place the enclosure
upside-down on a horizontal surface. To protect the finish,
place the enclosure on a soft cloth or rubber mat.
3 . Bolt the clamshell to the enclosure with two bolts and flat
washers included in the return kit (figure B-2).
Figure B-2 — Attaching the clamshell