Setup and operation, cont’d, Signal – Extron Electronics IR 452 User Manual
Page 14
IR 452 • Setup and Operation
Setup and Operation, cont’d
2-14
IR 452 • Setup and Operation
2-15
Controlling the MLC 104
The IR 452 can control an MLC 104 through a DVCM 50 that is
connected to the MLC rear panel host port.
Refer to the DVCM 50 User's Manual for wiring
instructions.
IR 452 to MLC 104 communication process
The following occurs when you press a button on the IR 452:
1
.
An IR signal goes from the button to the IR Link or IRL 20,
then to the DVCM.
2
.
The DVCM interprets the IR signal and responds to it by
sending the appropriate SIS command to the MLC 104.
You do not need to program any buttons on the
DVCM 50 for it to interpret the signals it receives from
the IR 452.
CONFIG
SIS commands
from DVCM 50
IR 452
SY
STE
M REM
O
TE
FR
O
NT
PA
NEL
DV
D
VCR
D
V
D
V
C
R
T
V
/V
C
R
V
O
L
V
O
L
P
C
V
ID
E
O
C
H
A
N
N
E
L
IR
452
SIGNAL
IR LINK
IR Link
SIGNAL
IR LINK
MLC 104
DVCM 50
CONFIG
PROJECTOR
VOLUME
ON
VIDEO
AUX
VIDEO
PC
IMAGE
MUTE
OFF
1
2
3
4
Remote control of the MLC 104
3
.
The MLC 104 activates the button on its front panel that
is associated with the SIS command it receives. When the
button is activated, the command programmed to it is sent
to the projector or display device.
The
following
fi gure shows the buttons that become
available when VCR mode is selected:
SYSTEM REMOTE
DVD
VCR
DVD
VCR
TV/VCR
VOL
VOL
PC
VIDEO
CHANNEL
IR 452
POWER
ON
FRONT PANEL
Press this
button first.
VCR control buttons on the IR 452