Edimax Technology AC-M1000 - Manual (Page 36)

Edimax AC-M3000/AC-M1000
User’s Manual
34
Operation Mode: Choose one of the two modes, NAT mode and Router mode, according to requirements.
IP Address: Enter the desired IP address for the interface of the controlled port.
Subnet Mask: Enter the desired subnet mask for the controlled port.
y DHCP Server Configuration
There are three types of DHCP server methods: Disable DHCP Server, Enable DHCP Server and Enable
DHCP Relay.
1. Disable DHCP Server: Disable DHCP Server function of Edimax AC-M3000.
2. Enable DHCP Server: Choose Enable DHCP Sever function and set the appropriate configuration for the
built-in DHCP server of Edimax AC-M3000. The fields with red asterisks are required. Please fill in these
fields.
DHCP Scope: Enter the “Start IP Address” and the “End IP Address”. Start IP Address means the fist
IP address of the DHCP scope. End IP Address means the last IP address of the DHCP scope. These two
settings define the IP address range that will be assigned to the clients’ of Uncontrolled Port.