Emerson EWC19D1 - Manual (Page 16)

– 16 – EN
0C28
– 16 –
WATCHING A TV PROGRAM
1
Select the desired channel with the CH(annel) K or
L
button.
2
Adjust the volume to the desired listening level using
the VOL(ume) K or L button.
3
Adjust picture controls for a natural looking image.
(See "PICTURE ADJUSTMENT".)
Note: Suppose that the TV/DVD is shut off or in any
other mode than TV. Press the CHANNEL K or L
button on the TV/DVD, and the TV/DVD will be in
the TV mode to watch television.
SELECTING THE SLEEP TIMER
The sleep timer function enables you to shut off the
power without pressing the POWER button after a
desired time period.
1
Press the SLEEP button on the remote control.
2
You may change the sleep time
with pressing the SLEEP button on
the remote control repeatedly. The
timer is set up to 90 minutes, 10
minutes each time the SLEEP button is pushed. (The
timer display counts up and sleep timer will be dis-
played on the screen when you press the SLEEP but-
ton on remote control.)
NOTES:
• When you disconnect the unit from the AC outlet,
or if you have a power failure, the sleep time will
be lost.
• When the TV mode is changed to the DVD mode,
the sleep time will be lost.
SLEEP 10
To cancel the sleep timer:
Press the SLEEP button repeatedly until "SLEEP 0"
is displayed.
CLOSED CAPTION
This TV can receive C1 and C2 of Caption and Text.
CAPTION MODE
1)Characters can be displayed on the TV screen when
the received broadcast signal contains the Caption
Signals.
2)Paint-on mode: Displays input characters on the
screen immediately.
Pop-on mode: Once characters are stored in mem-
ory, it is displayed all at once.
Roll-up mode: Displays the characters continuous-
ly by scrolling (max. 4 lines)
NOTE: If the CAPTION C1 or C2 is selected but the
caption signal is not included, characters will not be
displayed.
TEXT MODE
1)Displays the text on the screen by scrolling (max. 7
lines)
2)If the received broadcast signal does not contain
the caption or text signal, no change will occur.
NOTES:
1)When your TV receives a special effects playback
signal (i.e., Search, Slow, Still) from a VCR’s
video output channel (CH3 or CH4), your TV may
not display the correct caption or text.
2)Captions and texts may not match the TV voice
exactly.
3)Interference may cause the closed caption system
not to function properly.
4)The caption or text characters will not be displayed
while the setup display or function’s display is
shown.
OPERATIONS
DEGAUSSING
Magnetism from nearby appliances might affect the
color of the TV picture.
If this happens, move this unit away from the appli-
ance. If the color is still not correct, disconnect power
cord from AC outlet then reconnect it after 30 minutes.
TD251EN 01.5.31 7:15 PM Page 16