Emerson EWC19D1 - Manual (Page 10)

– 10 – EN
0C28
– 10 –
ANTENNA/CABLE CONNECTIONS
VHF/UHF COMBINED ANTENNA
The VHF/UHF Rod Antenna (not supplied) is detachable. Insert the stem of the antenna into the hole on the
upper-back portion of the TV/DVD. Connect the VHF/UHF Rod Antenna or VHF/UHF Combination Antenna
to the ANT. terminal of the TV/DVD as shown in the diagram below. For the best reception, fully extend the
VHF/UHF Rod Antenna and make the necessary adjustments. (Avoid touching the top section when adjusting.)
NOTE:
Before plugging the Rod antenna into antenna terminal, check that the pin is not bent. If it is bent, straighten
the pin as illustrated, then plug the pin into antenna terminal.
VHF/UHF SEPARATE ANTENNAS
In some areas it will be necessary to use an outdoor antenna.
L R AUDIO OUT
1
DIGITAL OUT COAXIAL
ANT.
ANT.
Bent pin
Cable Plug
(Needs to be straightened) (Straight pin)
L R AUDIO OUT
1
DIGITAL OUT COAXIAL
ANT.
ANT.
NOTE:
The connection of an indoor antenna may not always give acceptable TV reception.
[Fig. 4]
[Fig. 5]
Rod Antenna
(Not supplied)
VHF/UHF Antenna
(Not supplied)
VHF/UHF
Combiner
(Not
supplied)
Flat twin-lead cable
UHF Antenna
(Not supplied)
VHF Antenna (Not supplied)
PREPARATION FOR USE
TD251EN 01.5.31 7:15 PM Page 10