Epson EB-440W - Manual (Page 100)

Check Remedy
Is a wide-panel computer image being projected?
Only when projecting computer images
Change the setting according to the signal for the connected equipment. s Signal menu - Resolution p.75
Is the correct resolution selected?
Only when projecting computer images
Set the computer so that the signals being output are compatible with the projector.
s "List of Supported Resolutions" p.119 s Computer's documentation
Interference or distortion appear in images
Check Remedy
Is the image signal format setting correct?
Only when projecting images from a video source
Change the setting according to the signal for the connected equipment. s Signal Menu - Video Signal p.75
Are the cables connected correctly? Check that all the cables required for projection are securely connected. s Quick Start Guide
Is an extension cable being used? If an extension cable is used, electrical interference may affect the signals. Use the cables supplied with the projector to
check if the cables you are using may be causing the problem.
Is the correct resolution selected?
Only when projecting computer images
Set the computer so that the signals being output are compatible with the projector.
s "List of Supported Resolutions" p.119 s Computer's documentation
Are the "Sync. g " and "Tracking g " settings adjusted correctly?
Only when projecting computer images
Press the [Auto] button on the remote control or the [Enter] button on the control panel to perform automatic
adjustment. If the images are not adjusted correctly even after performing automatic adjustment, you can also make
adjustments with Sync. and Tracking in the Configuration Menu. s Signal Menu - Tracking and Sync.
p.75
The image is truncated (large) or small, or the aspect is not suitable
Check Remedy
Is a wide panel computer image being projected?
Only when projecting computer images
Change the setting according to the signal for the connected equipment. s Signal menu - Resolution p.75
Is the image still enlarged by E-Zoom? Press the [Esc] button on the remote control to cancel E-Zoom. s p.47
Is the display position adjusted correctly? Press the [Auto] button on the remote control or the [Enter] button on the control panel to perform automatic
adjustment while a computer image is being projected. If the images are not adjusted correctly even after performing
automatic adjustment, you can also make adjustments using Position from the Configuration Menu.
When projecting signals other than computer image signals, make adjustments with Position in the Configuration
Menu. s Signal Menu - Position
p.75
Problem Solving
100