Problems when projection starts, Problems relating to monitoring and control, The projector does not turn on – Epson EB-440W User Manual
Page 102: P.102, Problem solving
Problems when projection starts
The projector does not turn on
Check
Remedy
Did you press the [t] button?
Press the [t] button to turn the power on.
Are all of the indicators off?
The power cable is not connected correctly or power is not being supplied.
Disconnect and then reconnect the power cable. s Quick Start Guide
Check the breaker and so on to ensure power is being supplied.
If the lamp cover or the lamp are not installed correctly, the lamp will not turn on.
Check that the lamp cover and lamp are installed properly. s
Do the indicators turn on and off when the power cable is touched? There is probably a poor contact in the power cable, or the power cable may be defective. Reinsert the power cable. If this
does not solve the problem, stop using the projector, disconnect the power cable from the electrical outlet, and contact
your local dealer or the nearest address provided in the Support and Service Guide. s
Epson Projector Contact List
Is Control Panel Lock set to Full Lock?
Press the [t] button on the remote control. If you do not want to use Control Panel Lock, change the setting to Off.
s
Settings Menu - Control Panel Lock
Is the correct setting for the remote receiver selected?
Check the Remote Receiver setting from the Configuration Menu. s Settings Menu - Remote Receiver
Problems relating to monitoring and control
Mail is not received even if an error occurs with the projector
Check
Remedy
Is the Wireless LAN unit installed?
For wireless LAN
Check that the optional Wireless LAN unit is installed in the projector properly.
Is the network cable connected correctly?
For wired LAN
Check that the network cable is connected correctly. Reconnect it if it is not connected or not connected properly.
Are the network connection settings correct?
Check the projector's network settings. s
Is Standby Mode set to Communication On?
To use Mail Notification when the projector is in a standby state, set Standby Mode to Communication On from the
Configuration Menu. s Extended menu - Standby Mode
Problem Solving
102