Epson EB-440W - Manual (Page 88)

Others Menu
Sub-menu Function
SNMP Set whether or not (On/Off) to use SNMP.
Trap IP Address 1
Trap IP Address 2 You can register up to two IP addresses for the SNMP g trap notification destination.
You can input a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used.
127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a number from 0 to 255)
To use SNMP to monitor the projector, the SNMP manager program needs to be installed on your computer. Make sure management by SNMP is
performed by the network administrator.
Priority gateway For the priority gateway, select either wireless or wired.
AMX Device Discovery g When the projector is connected to a network, set this to On when you want to allow the projector to be detected by AMX Device Discovery. Set this to
Off
if you are not connected to an environment controlled with a controller from AMX or AMX Device Discovery.
List of Functions
88