Powerplus POWXQ5313 CIRCULAR SAW 1350W 185MM EN - Manual (Page 8)

POWXQ5313 EN
Copyright © 2014 VARO P a g e | 8 www.varo.com
10 CLEANING AND MAINTENANCE
Attention! Before performing any work on the equipment, pull the power
plug (1).
10.1 Cleaning
 Keep the ventilation slots of the machine clean to prevent overheating of the engine.
 Regularly clean the machine housing with a soft cloth, preferably after each use.
 Keep the ventilation slots free from dust and dirt.
 If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These
solvents may damage the plastic parts.
10.2 Checking and replacing the carbon brushes
The carbon brushes must be checked on a regular basis.
 In case of wear, replace both carbon brushes at the same time.
 Mount the carbon brush holders.
 After mounting new carbon brushes, let the machine run at no load for 15 minutes.
Use only the correct type of carbon brushes.
10.3 Service department
If the connecting cable (or mains plug) is damaged, it must be replaced. Replacement of the
connecting cable should only be carried out by a qualified specialist (qualified electrician).
11 TECHNICAL DATA
POWXQ5313
Rated voltage 230-240V
Rated frequency 50Hz
Rated input 1350W
No load speed 5000min
-1
Max cutting depth 90° 62mm
Max cutting depth 45° 41mm
Blade 185 x 20 x 2.4 mm
Teeth 24T
Degree of protection IP20
Protection class Double insulated
Weight 4.16 kg
Construction Hand-held
Supply connection Non detachable cord
Rated operation Continuous operation
12 NOISE AND VIBRATION
Noise emission values measured according to relevant standard. (k=3)
Sound pressure level LpA
92dB(A)
Sound power level LwA 103dB(A)