beautypg.com

Petrol safety warnings, Assembly instructions, Step 1: install the depth regulator – Powerplus POWXG7205 CULTIVATOR 196CC EN User Manual

Page 6

background image

POWXG7205

EN

Copyright © 2014 VARO NV

P a g e

| 6

www.varo.com

 Till across the slope (at equally spaced intervals) rather than up and down it.
 Be very careful when changing the direction of the cultivator on a slope.
 Do not use the cultivator on a slope of more than 10°. The maximum angle for safe

working (as shown) is for reference purposes only and should be determined according to
the type of tool.

 Before starting the engine, check that the cultivator is not damaged and is in good

condition. For your safety and the safety of others, exercise extreme care when using the
cultivator up or down a hill.

6 PETROL SAFETY WARNINGS

WARNING: Use extra care in handling fuels. They are inflammable and the
vapours are explosive. The following points must be observed.

 Use only an approved container.
 Never remove the fuel cap or add fuel with the power source running. Allow engine

exhaust components to cool before refueling.

 Do not smoke.
 Never refuel the machine indoors.
 Never store the machine or fuel containers inside where there is an open flame, such as a

water heater.

 If fuel is spilled, do not attempt to start the power source, but move the machine away

from the area of spillage before starting.

 Always replace and securely tighten the fuel cap after refueling.
 If the tank is drained, this should be done outdoors.

7 ASSEMBLY INSTRUCTIONS

The cultivator comes fully assembled except for a few parts. The following instructions will
help you assemble and adjust the cultivator's depth regulator, cable tension, and handlebar
height.

7.1

Step 1: install the depth regulator

 Install the depth regulator into the top of the

depth regulator bracket with handle facing
rearwards.

 Insert depth regulator bolt through depth

regulator bracket into hole in depth regulator
lever so that tines clear the ground.


A) Front
B) Depth Regulator bracket
C) Rear
D) Depth regulator bolt
 E) Depth regulator