Powerplus POWXG7205 CULTIVATOR 196CC EN - Manual (Page 11)

POWXG7205 EN
Copyright © 2014 VARO NV P a g e | 11 www.varo.com
9.2 Handlebar height adjustment
The ideal height of the handlebar varies with
operator height and tilling depth. To adjust
handlebar height:
 Unscrew nuts and remove top bolts on each
side.
 Align handlebar to desired holes.
 Install bolts and nuts. Retighten.
A) Lock nuts
B) Height adjustment bolts
C) Height adjustment holes
D) Transmission cover
9.3 Depth regulator lever
Tilling depth is controlled by the height of the
depth regulator lever. To adjust tilling depth:
 Turn loose depth regulator bolt
 Raise the depth regulator lever to position
tines at chosen tilling depth.
 Align hole in depth regulator lever with hole in
depth regulator bracket and replace depth
regulator bolt.
Depth Regulator Lever Down = Shallower tilling.
Place the depth regulator bolt in the top hole of
the depth regulator lever for shallowest tilling.
Depth Regulator Lever Up = Deeper tilling.
Place the depth regulator bolt in the bottom hole
of the depth regulator lever for deepest tilling.
A) Front
B) Depth Regulator bracket
C) Rear
D) Depth regulator bolt
E) Depth regulator
9.4 Belt tension adjustment
Proper belt tension is critical to good performance. After 1/2 hour of operation, all cables may
have to be adjusted due to initial stretch. Thereafter, check tension after every 2 hours of
operation.
To increase belt tension: