Powerplus POWX067 ANGLE GRINDER 2450W 230MM EN - Manual (Page 8)

POWX067
EN
Copyright © 2010 VARO p a g e | 8 www.varo.com
7.3 Replacing the grinding disc
Beware – a disc which has been used may be very hot!
Fig. 4 Fig. 5
§ Pull out the power plug from the mains socket.
§ Depress and hold down the spindle lock button (2) to secure the spindle.
§ Turn the shaft until it locks.
§ Remove the
outer flange (a) and backing flange (b) by using the two-hole spanner
provided.
§ Fit the desired disc (10) on the spindle and replace the outer flange and backing flange.
Release the spindle lock.
Important! Only ever press the spindle lock when the motor and grinding
spindle are at a standstill!
You must keep the spindle lock pressed while you change the wheel !
For grinding or cutting wheels up to approx. 3 mm thick, screw on the flange nut with the flat
side facing the grinding or cutting wheel.