Powerplus POWX067 ANGLE GRINDER 2450W 230MM EN User Manual

Page 10

POWX067

p a g e

www.varo.com

8 OPERATON MODES

8.1

Grinding

Hold the handle (4) and auxiliary handle (8) firmly and
switch on. Avoid blocking the ventilation slots with your
hand, as this may cause the grinder to overheat. Let the
disc reach full speed. Apply the grinder to the item.
Maximum effect is achieved when the grinder is held at
an angle of 15-30°in relation to the item. Move the
grinder gently along the item. Give the grinder time to

work. It is rarely necessary to press the disc hard against the surface to be worked. Sparks
can occur in the motor compartment during use. This is normal and does not mean the grinder
is defective. Switch off the grinder after use.

8.2

Splitting

Splinters of splitting disc may be ejected at a very high speed. Do not apply
any side pressure to the wheel, as the cutting wheel can jam and burst.

Fig. 8

1. Fit the splitting disc.
2. Switch the tool on and run it first without load.
3. Hold the motor block at an angle between 30°and 45°to the workpiece.
4. Guide the disc slowly and evenly along the planned line of cut.

9 FLANGE ARRANGEMENTS WHEN USING GRINDING WHEELS AND

CUTTING WHEELS

9.1

Flange arrangements when using a depressed centre or straight grinding wheel

1 Clamping flange
2 Flange nut