Powerplus POWX0560 PLUNGE SAW 1200W 165MM EN - Manual (Page 9)

POWX0560
EN
Copyright © 2014 VARO P a g e | 9 www.varo.com
9.2 Checking and replacing the carbon brushes (fig. A)
The carbon brushes must be checked on a regular basis.
 In case of wear, replace both carbon brushes at the same time.
 Mount the carbon brush holders.
 After mounting new carbon brushes, let the machine run at no load for 15 minutes.
Use only the correct type of carbon brushes.
9.3 Lubrication (fig. B)
From time to time, apply a drop of oil to the thread of the lock screw (17).
10 TECHNICAL DATA
type POW
Х0560
Voltage / frequency 230-240 V / 50 Hz
Power input 1200 W
Speed 5500 min
-1
Max speed rating saw blade 8500 min
-1
Saw blade Ø 165 x Ø 20 x 2.5 mm – 24T
Max cutting depth 54 mm (90°)
38 mm (45°)
Mitre angle 0-48

11 NOISE
Noise emission values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
89 dB(A)
Acoustic power level LwA 100 dB(A)
ATTENTION! Wear hearing protection when sound pressure is
over 85 dB(A).
aw (Vibration) 5,8 m/s² K = 1,5 m/s²
12 SERVICE DEPARTMENT
 Damaged switches must be replaced by our after-sales service department.
 If the connecting cable (or mains plug) is damaged, it must be replaced by a particular
connecting cable which is available from our service department. Replacement of the
connecting cable must only be carried out by our service department (see last page) or by
a qualified person (qualified electrician).
13 STORAGE
 Thoroughly clean the whole machine and its accessories.
 Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
 Protect it from exposure to direct sunlight. Keep it in the dark, if possible.

Don’t keep it in plastic bags to avoid humidity build-up.