beautypg.com

Switch (fig. 5 & fig. 6), Rotation (right/left/lock), Variable speed – Powerplus POWX0058BAG DRILL/SCREWDRIVER 18V 2 BATT EN User Manual

Page 9: Adjusting the torque

background image

POWX0058BAG

EN

Copyright © 2014 VARO

P a g e

| 9

www.varo.com

7.4

Switch (Fig. 5 & Fig. 6)

Fig. 5 Fig. 6

The drill is started and stopped by depressing and releasing the ON/OFF switch trigger (7).
This cordless drill is equipped with an electric brake, when the ON/OFF switch trigger is
released completely the chuck stops immediately.

7.4.1

Rotation (right/left/lock)

Direction of rotation is controlled by the direction of rotation selector (6) located above the
switch trigger.
Right : To select forward rotation, release the on/off switch and push the forward/reverse lever
to the left side of the tool.
Left : To select reverse rotation, push the lever to the right side of the tool.
Lock: When the selector is in the center position, the switch trigger is locked. (See Fig. 6)
This helps to reduce the possibility of accidental starting when not in use

7.4.2

Variable speed

This tool has a variable speed switch that delivers higher speed and torque with increased
trigger pressure. The rotational speed is controlled by the amount of switch trigger depression.

7.5

Adjusting the torque

The torque is adjusted by rotating the torque setting ring (2); the torque is greater when the
torque setting is set on a higher position. The torque is less when the torque setting ring is set

on a low position. Position

1”denotes the lowest and “

” denote the highest.

The torque force is set by means of a torque setting according to the size of screw and the
kind of material. Select the suitable torque for the job to be performed .. long screws and/or
hard material require a higher torque setting.

This manual is related to the following products: