Powerplus POWX0058BAG DRILL/SCREWDRIVER 18V 2 BATT EN - Manual (Page 11)

POWX0058BAG EN
Copyright © 2014 VARO P a g e | 11 www.varo.com
7.8 Magnetic Drill/Bit Holder and Bit Holder
Fig. 9
At the base of the cordless drill there is a
magnetic drill/bit holder (12).
It can be used to hold various drill/bits while
completing a job.
7.9 To recharge the battery pack
Fig. 10
If you press the button for LCD battery
capacity indicator (5) on the cordless drill,
you can check the capacity status of the
battery. Before use the machine, please
press the button to check if the battery is full
enough for properly working.
The battery status display shows the
capacity level of the battery. (%)
NOTE: Please charge the battery after each
use, it is necessary to charge the battery
once per month if the machine is not used .
NI-CD : (POWX0058BAG)
NOTE : before recharging, always make
sure the battery is exhausted, just topping
upthe charge affects the capacity of your
Ni-Cd battery negatively (it will diminish).
7.10 Drilling
Before drilling, the torque setting should be set on the drill position “ ”.
When drilling hard smooth surface, use a center punch to mark the desired hole location. This
will prevent the drill bit from slipping off center as the hole is started. Hold the tool firmly and
place the tip of the drill or bit into the work piece, applying only enough pressure to keep the
bit cutting. Do not force or apply side pressure to elongate a hole.