Operation, Charging the battery pack (fig 2) – Powerplus POWX0058BAG DRILL/SCREWDRIVER 18V 2 BATT EN User Manual
Page 7
POWX0058BAG
EN
Copyright © 2014 VARO
P a g e
| 7
www.varo.com
7 OPERATION
7.1
Charging the battery pack (fig 2)
Fig. 2
The battery pack has been shipped in a low charge condition to prevent possible problem. You
should charge them prior to use.
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles
(drilling followed by recharging) for the item to fully charge. The battery should only be used
indoors.
The battery as supplied is not fully charged. Therefore, let the tool charge initially for 7 hours.
After the initial Charge, under normal usage, your tool should be fully charged in 3 to 5 hours.
The battery pack will become slightly warm to the touch while charging, this is normal and
does not indicate a problem.
Do not place the charger in an area of extreme heat or cold, it will best at normal room
temperature.
Charging indication:
When the charger station is plugged in the red LED turns on
When the charger station is pushed on to the battery the green LED will also light.
Battery pack
Charger station
Red light
adaptor