Powerplus POW8041 MITRE SAW +UPPER TABLE 1200W 210MM EN - Manual (Page 9)

POW8041 EN
Copyright © 2014 VARO P a g e | 9 www.varo.com
 Always push the workpiece through as far as the end of the (30) splitter. {Fig. 7)
 When the cut is completed, the guard hood (17) closes, again automatically and covers
the blade (5).
 Switch off the saw.
Important: Secure long workpieces from sagging at the end of the cut (e.g.
with a roller table etc.).
7.1.4 Making cross cuts (Fig. 8/9)
 Insert the cross and parallel stop (18) from the right into the lateral slot of the saw table
(16).
 Tighten the locking screw (28) until the cross stop (18) can be moved in the slot of the saw
table (16) with little play.
 Slacken the knurled screw (25), move the cross stop (18) to the required angular setting
and fix in position.
 Slacken the two knurled screws (26) and Slide the stop rail (27) to the left until it no longer
touches the blade guard (17) when moved forward. Re-tighten the screws (26).
 Switch on the saw.
 Press the workpiece firmly against the stop rail (27) and slowly slide it together with the
cross stop (18) against the blade (5) *n order to make the cut.
 When the cut is completed, switch off the saw.
7.2 Using as a mitre box saw
Convert the saw to mitre-box saw mode (see 6.2.1)
7.2.1 Settings (Fig. 2/3)
 The machine head can be tilted a max. 45 ° lo the left by undoing the clamping screw (22)
with the hex wrench (19).
 The rotary table (8) can be adjusted from -45 ° to +45A by undoing the locking screws (10).
7.2.2 On/Off switch {Fig. 2)
 The saw is started by pressing the On/Off switch (3). The switch has to be kept pressed
while making the cut.
7.2.3 90° cross-cuts and 0° rotary table (Fig. 2)
Convert the saw from bench-type circular saw mode to mitre box saw mode.
 Press the main switch (3) to turn on the saw.
 Wait for the blade to reach its maximum speed before starting the cut.
 Place the workpiece on the lower saw table (9) and press it against the stop rail with your
left hand. Always position the material firmly on the machine bed so that it cannot move
about while it is being cut.
 With the other hand, press the release button (1) and lower the machine head by its
handle (2) smoothly and with slight pressure down through the workpiece to make the cut.
 When the cut is completed, return the machine to its top parking position and let go of the
On/Off switch.
Caution! A return spring causes the machine head to rise automatically at
the end of the cut. Do not let go of the handle (2) as soon as the cut is
completed but steady the machine head and allow it to rise slowly,