Powerplus POW7490 TILE CUTTER 600W 180MM 180MM EN - Manual (Page 6)

POW7490
EN
Copyright © 2015 VARO P a g e | 6 www.varo.com
 Check with a qualified electrician or service personnel if the grounding instructions are not
completely understood, or if in doubt as to whether the tool is properly grounded.
6.2 Diamond blades
 Only use 180mm diameter Continuous Rim Wet Diamond blades.
 DO NOT use larger, segmented or 'turbo' blades, wood sawing blades, or any other
cutting device. Severe bodily injury, and damage to your saw can occur.
 Inspect blades daily for cracks or uneven wear. Discard cracked, chipped or bent blades!
 Ensure the blade is mounted with the rotation arrow in the proper direction and is securely
tightened with a wrench.
 Always ensure a continuous flow of water on both sides of the blade before cutting any
material.
 Do not operate the machine without all safety guards in position
 Do not force the material into the blade. Let the blade cut at its own speed.
7 ASSEMBLY
ATTENTION! Disconnect the power plug before carrying out any
adjustments or maintenance.
7.1 Mounting the riving knife (fig. 1)
 Unscrew the two (crosshead) screws and place the foot of the riving knife under the table.
 Place the small plate (2 holes with thread) under the foot of the riving knife
 Connect the riving knife with the two screws and the plate
7.2 Mounting the cutting disc (fig. 2 & 3)
 Unscrew two screws out of lower blade guard and remove the guard. (fig. 2)
 Dismount nut (counterclockwise) and outer flange
 Place blade on the inner flange
 Mount outer flange and nut (clockwise) again (fig. 3)
 Place the lower blade guard back in position and connect the two screws
7.3 Mounting the upper blade guard (10) (fig. 4)
 Slide the guard in horizontal position across the riving knife.
 Connect the guard to the riving knife with the wing nut bolt and the locknut
 Be aware that the guard is connected under the lockpin. The lock-pin prevents the guard
falling backwards.
7.4 Mounting the adjustable fence
 Connect the knob (7) with the fence (3) by using the plate (1 hole with thread); do not
tighten the knob yet.
 Slide the complete fence with (loosen) knobs onto the table; the plates on the inner side of
the table.
 Set the required distance.
 Tighten the knobs by rotating them (clockwise).
 Place the water reservoir (4) under the table
8 OPERATION
 The tile cutter may only be used as a fixed tool and should be screwed down to a level
and horizontal surface.
 Use the screw holes in the base of the machine.
 Keep water full in the tank when you operate the cutter.