Powerplus POWXQ53600T STAND TABLE SAW EN - Manual

POWXQ53600T EN
Copyright © 2013 VARO P a g e | 1 www.varo.com
STAND FOR TABLE SAW
POWXQ53600T
1 PACKAGE CONTENT LIST
 Remove all packaging materials.
 Remove remaining packing and package inserts (if included).
 Check that the package contents are complete.
 Check the appliance, the power cord, the power plug and all accessories for transportation
damage.
 Keep the packing materials as far as possible till the end of the warranty period. Dispose it
into your local waste disposal system afterwards.
WARNING: Packaging materials are not toys! Children must not play with
plastic bags! Danger of suffocation!
1. Nut holder
2. Table-
raising/lowering
bolt
3. Washer
4. Bolt
5. Bearing
6. Plate
7. Preinstalled nut on
the stand
8. Hole of the stand
9. Carrying handle
10. Nut
11. Bolt
12. Groove in the
carrying handle
13. Locking pedal
14. Bolt
15. Washer
16. Leg
17. Nut
18. Tire wheel
19. Bolt
20. Holes in your tool
base
21. Holes in the stand
22. Table-
raising/lowering
wheel handle
23. Foot
24. Nut
25. Hex bolts
26. Fix plate
27. Bolt
28. Washer
If any parts are missing or damaged, please contact your dealer.
2 GENERAL SAFETY WARNINGS
 Read and thoroughly understand this manual and the instruction manual of the tool you
use before performing the following.
 Before installing a tool on this stand, always switch off and unplug the tool.
 The stand should be bolted in a stable and level surface using the bolts provided on two of
four feet.
 Use only the handle to avoid pinched fingers when raising or folding the stand.
 Before operating the tool, secure it to stand using bolts.
 Do not use the stand on uneven or unstable surface.
 Do not climb, sit or stand on the stand.
 When storing table saw stand, never lean it against the wall or the like lengthwise or
sideways.
3 ASSEMBLING
1. Take out the stand from the carton box and place it on its side. (Fig. 1)
2. Move the leg in the direction of arrow and then remove the table-raising/lowering bolt with
a spring from the nut holder. (Fig. 1, 2)
3. Remove a bolt and a washer from the top of the table-raising/lowering bolt with the hex
wrench.