Powerplus POW7490 TILE CUTTER 600W 180MM 180MM EN - Manual (Page 5)

POW7490
EN
Copyright © 2015 VARO P a g e | 5 www.varo.com
5.4 Power tool use and care
 Do not expect the power tool to do more than it can. Use the correct power tool for what
you want to do. A power tool will achieve better results and be safer if used in the context
for which it was designed.
 Do not use the power tool if the switch cannot turn it on and off. A power tool with a
broken switch is dangerous and must be repaired.
 Disconnect the plug from the power source before making adjustments, changing
accessories, or storing power tools. Such preventive safety measures reduce the risk of
starting the power tool accidentally.
 Store power tools, when not in use, out of the reach of children and do not allow people
who are not familiar with the power tool or these instructions to operate it. Power tools are
potentially dangerous in the hands of untrained users.
 Maintain power tools. Check for misalignment or jammed moving parts, breakages or any
other feature that might affect the operation of the power tool. If it is damaged, the power
tool must be repaired. Many accidents are caused by using poorly maintained power tools.
 Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to jam and are easier to control.
 Use the power tool, accessories and cutting tools, etc., in accordance with these
instructions and in the manner intended for the particular type of power tool, taking into
account the working conditions and the work which needs to be done. Using a power tool
in ways for which it was not intended can lead to potentially hazardous situations.
5.5 Service
 Your power tool should be serviced by a qualified specialist using only standard spare
parts. This will ensure that it meets the required safety standards.
6 ADDITIONAL SAFETY INSTRUCTIONS FOR TILE CUTTERS
 Make sure that the cutting disc is correctly screened by the guard.
 Never remove the riving knife. The distance between the cutting disc and the riving knife
should not exceed 5 mm.
 Do not use cutting discs which are bent, deformed or otherwise damaged.
 Do not use cutting discs which do not comply with the specifications stated in this manual.
 Never start cutting tiles before the machine reaches full speed.
 Never attempt to cut extremely small workpieces.
 Do not leave the work area until the machine has been switched off and the cutting disc
has come to a complete standstill.
 Never attempt to stop the cutting disc by exerting pressure on the side of the disc.
 Always unplug the machine before performing any maintenance.
 Do not use the machine before it has been completely assembled and installed according
to the instructions.
 Do not perform any design, assembly or Construction activities on the table while the
machine is switched on.
 Unplug the machine and clean the table before leaving the work area.
6.1 Power supply
 This tile saw must be connected to an earthed 230V - 50Hz power source.
 This power source must be secured by a 16A fuse.
 Your machine is supplied with a 30mA residual current device to protect the user against
electric shock.
 It can only protect you when the power mains to which the tool is plugged is properly
grounded.
 Have the proper outlet installed by a qualified electrician.