Eicon Networks V8.3 - Manual (Page 43)

Dial-Up Networking and RAS Administration 43
CHAPTER
5
Dial-Up Networking and RAS
Administration
In the terminology used by the Remote Access Service, the calling station is referred to
as the Client and the called station as the Server. The RAS client/server architecture
allows a station to be defined simultaneously as a server and as a client and therefore
enables simultaneous initiation of outgoing and incoming ISDN connections. For example,
this enables the peer-to-peer connection of two Windows 2000 or Windows XP
workstations.
RAS client setup
The RAS client can be used to establish connections to the following remote stations:
• Windows 2000, Windows XP, or Windows Server 2003 computer with RAS in server
mode
• Internet Service Provider
• TCP/IP router
Setting up a RAS client under Windows 2000, Windows XP, or Windows
Server 2003
Under Windows 2000:
1. Click ‘Start > Settings > Network and Dial-up Connections’.
2. In the ‘Network and Dial-up Connections’ box, double-click ‘Make New Connection’.
3. If the ‘Location Information’ box appears, enter the country/region you are in. Enter
your area code and, if required, your number to access an outside line.
Click ‘OK’.
4. If the ‘Phone and Modem Options’ box appears, select your location.
Click ‘OK’.
5. In the ‘Network Connection Wizard’, click ‘Next’.