Epson Long-Focal Length zoom lens ELPLL02 - Manual (Page 15)

13
2. Mounting the rear-projection wide-angle lens
Warning
Be sure to disconnect the power cable before installa-
tion, because there is danger of electrical shock.
Memo Always mount and dismount the lens in a
clean room, to minimize the amount of dust.
Excessive dust inside the lens could cause
damage.
•
Note that the illustrations below may not match your particu-
lar projector model.
Front case
Screws (two)
2-1 Removing the current lens
(1) Remove the front case.
1. Remove the two mounting screws, and pull off the front case.
01.2.15, 4:17 PM Page 13