Casio PCR-T500 - Manual (Page 75)

E-75
Usef
u
l f
e
at
ure
s
Advanced programmings and registrations
Programming functions of departments and PLUs individually
Programming functions of departments individually
This part explains programming methods of each function of departments indi-
vidually.
Step Operation
1
Turn the Mode switch to PGM position and select [System
Setting] then press F key.
> ▪▪▪▪▪ >F
2
Enter 3 and press o key to set the register in the
programming mode.
3o
3
Referring the following table, enter two-digit set code you
wish to program followed by two 6s. The “66” is the identifi -
cation code for individual programming of departments and
PLUs. Then press
o key.
BB66o
(set code)
4
You can skip this step if you program in departments 01
through 25. If you wish to program in departments 26
through 50, press
DEPT
SHIFT/
DEPT#
key.
DEPT
SHIFT/
DEPT#
5
Referring the following table, enter program code and press
the department key in which you wish to set.
123#
This example is for linking dept. 03 to item
group 123 assuming set code 11 has been
entered in step 3 and
DEPT
SHIFT/ DEPT#
key is not pressed
in step 4.
6
If you wish to set the same function in another department,
press the corresponding dept. key.
$
This example is for setting the same linking
group in dept. 04.
7
Repeat steps 4 and 5 to set another function in another
department.
8
Press o key to complete the program.
o