Casio PCR-272 Manual - Manual (Page 11)

11
P
a
rt-1
11
E
Part-1 QUICK START OPERATION
3. Basic Programming for QUICK START Mode Switch
REG
OFF
RF
PGM
CAL X
Z
FOR PROGRAMMING ASSISTANCE, PLEASE CALL TOLL FREE 1-800-638-9228
Procedure Purpose
1. Turn the mode switch to PGM position. Programming
2. When the display shows blinking “0”, such as
00-00-00
,
enter current date in Month, Day, Year order.
Example: January 8, 2010: enter ?Z?
• Enter 6-digit, last 2 digits for year set. (2010 → 10)
• By pressing y, this procedure returns one by one.
Setting the
current date
3. When the display shows blinking “0”, such as
00-00
,
enter current time in Hour, Minute order.
Example: 1:18 PM, enter ZCZ<
• Enter 4-digit, use 24-hour system.
• By pressing y, this procedure returns one by one.
• If you want to adjust the date/ time, please refer to page 31 of this manual.
Setting the
current time
4. Input the desired fl at tax rate to the appropriate department key.
(This procedure below programs fl at tax rate only. If your tax table has break points, refer
to page 24 of this manual.)
A) Press the ~ key.
B) Enter tax rate. (Example: For 6% enter “6”, 5.75% enter “5.75”.)
C) Press the appropriate department key.
D) Repeat step B) and C) to set other department key.
E) Press the
k key to end tax programming.
Note: In case of setting the wrong tax rate to the key, please enter
?
and press those
department keys above, and quit this procedure by pressing
k key, and start from
the beginning of this procedure.
Please start with the department 2 key (taxable department). Department 1 key is
initialized as non taxable.
Setting the tax
rates
Example 1:
Set state tax 4% to department 2, 3 key.
~ Start tax program.
4 S
Enter tax rate and press dept key.
4 D Enter tax rate and press dept key.
k
To end the setting.
Example 2:
Set state tax 5% to department 2 and 7% to
department 3 key.
~ Start tax program.
5 S
Enter tax rate and press dept key.
7 D
Enter tax rate and press dept key.
k
To end the setting.