Casio PCR-272 Manual User Manual

Page 10

Part-1

QUICK START OPERATION

1. To load journal paper

Remove the printer cover by

lifting up the back.

Put a roll of journal paper

into the holder.

Cut the leading end of the

roll paper with scissors and
insert the paper into the inlet.

Press the

key until 20 or

30 cm of paper is fed from
the printer.

Roll the paper onto the take-

up reel a few turns.

Set the left plate of the take-

up reel and place the reel
into the register.

Load new paper following the

instructions above, and re-
place the printer cover.

Press the

key to take up

any slack in the paper.

Replace the printer cover by

placing the cover’s front tab
into the register’s groove.

2. To remove journal paper

Remove the printer cover fol-

lowing the instructions above.

Press the

key until ap-

proximately 20cm of the pa-
per is fed from the printer.

Cut off the roll paper.

Remove the take-up reel

from the printer and take off
the left plate of the reel.

Remove the journal paper

from the take-up reel.

Cut off the paper left in the

printer and press the

key

until the remaining paper is
fed out from the printer.

Remove the core of the pa-
per.

2. Loading Paper Roll And Replacing The Printer’s Ink Roll

Mode Switch

REG

OFF

PGM

CAL

◗ To load receipt paper

To use the printer to print re-

ceipts, follow steps 1 through
4 of “To load journal paper”.

Pass the leading end of the

receipt paper through the
printer cover’s paper outlet
and replace the printer cover.

Tear off any excess paper.

Default printer setting is for
Journal.To print receipts, please
refer to 1-7-3 on page 22 to
switch the printer for Receipt or
Journal.

Options: Roll paper – P-5860

Ink Roll – IR-40