Casio XJ-H2600 User Guide - Manual (Page 30)

30
You can capture a projected screen and save it as image data in the projector’s built-in memory.
Image data you save in projector memory is called a custom logo.
The following are ways you could use a custom logo.
– As a startup screen image that appears first whenever the projector is turned on
– As a default projection image whenever there is no input signal to the projector (No Signal Screen)
– As the screen projected whenever the [BLANK] key is pressed (Blank Screen)
Important!
Note that using the projector to save image data for commercial purposes or public presentation
may infringe on the legally protected copyright of the copyright holder of the original material.
To capture a screen and save it as the custom logo
Important!
z As soon as you start a screen capture with the operation below, any custom logo currently
stored in the projector’s memory is deleted.
z If you press the [ESC] key to interrupt an ongoing screen capture operation or if the capture
operation is interrupted for any other reason before it is complete, your custom logo data will
revert to the initial factory default image (light green image). However, depending on the timing
of the interruption, you may end up with a partial capture with part of the screen image being
registered as your custom logo.
z Once a screen capture operation is started, it takes a number of minutes for it to complete.
1.
If the projector is in the 3D Input Mode, switch it to the Normal Input Mode (page
18).
2.
Project the image you want to save as a custom logo onto the projection screen.
z Not all types of projection images are supported. For more information, see “Supported
Capture Images” (page 31).
3.
Press the [MENU] key to display the setup menu.
4.
Use the [
T] key to select “Option Settings 1”, and then press the [ENTER] key.
5.
Use the [
T] key to select “Custom Logo Capture” and then press the [ENTER]
key.
z If “On” is selected for “Option Settings 1 J Password protection J Logo Password”, a dialog
box prompting for input of the password will appear at this time. If this happens, input the
password and then press the [ENTER] key. For details about the logo password, see
“Password Protection” (page 32).
6.
When a dialog box with the confirmation message “Starts capture of the current
screen. OK to continue?” appears, press the [ENTER] key.
z As soon as you press the [ENTER] key, the projected image will become frozen and capture
will begin.
z The message “Screen capture complete.” will appear when capture is complete.
Custom Logo Capture