Information field, Operations – Casio DT-10 User Manual

Page 12

Figure 8 Advanced Settings Window

1.1.3.１ Information

Field

• Power Save Mode

Disable – Choosing this option will disable the power save mode.

Always Enable – Choosing this option will have the power save mode always enabled. This is the
default setting.

Auto Enable – When internal battery is being used it will be in Power Save mode; when external
power supply is being used the Power Save mode will be disabled automatically.

• Preamble Mode

Long TX Preamble – Where Sync field consists of 128 bits.

Short TX Preamble – Where Sync field consists of 56 bits.

Auto TX Preamble – Automatically change between long and short preamble mode transmission
based on the AP configurations. This is the default Preamble Mode.

Not : A Preamble consists of a Synchronization (Sync) field and a 16-bit Start Frame Delimiter (SFD)
field.

•

Help button

Open a context sensitive help window.

1.1.3.２ Operations

• Sliding bar

The leftmost position on the sliding bar (

B st P rformance) indicates that the WLAN station will listen to

every beacon from the associated AP. The default beacon interval is 100 ms for most APs. When the knob is
dragged to the right-hand-side, the station will listen to the beacon in multiple beacon intervals depending on
the position on the slide bar. The rightmost position (Best Battery Life) indicates the beacon interval is 10
times of AP’s beacon interval, i.e. 1000 ms when the beacon interval is set to 100ms. For the Sliding bar to take
effect, the

Power Save Mode needs to be either Alway Enable or Auto Enable, and you need to click on the

Apply button.