Casio EG-800 - Manual (Page 32)

32
Important
Do not use the ActiveSync backup function to back up data to a computer when you
suspect a data error. Doing so may also include the corrupted data that is causing your
problem, which means the problem will reappear when you restore the data.
Full Reset (Memory Initialize)
Full reset (memory initialize) deletes all data, and resets all unit parameters to their
initial defaults.
The following are conditions when you should perform a full reset.
• When you want to delete all memory data and return unit settings to their factory
defaults
• When you forget your password and need to clear it
• When a data error causes operational problems
• Appearance of the message: “A problem with memory contents has been found...”
Performing a Full Reset
Important
• The following procedure deletes all data in memory. Be sure that data is backed up or
that you no longer need it before performing the following procedure.
• If there is a CompactFlash Card in the CASSIOPEIA’s slot, remove the card before
performing the full reset.
1. Make sure that unit power is turned on.
2. While holding down the [Power] button, use the stylus to hold down the RESET
button for about two seconds.
• This causes the following message to appear on the display screen.
“Proceeding with this operation initializes memory. Press [Action] to proceed or
[Record] to cancel.”
3. Press the [Action] control.
• This causes the following message to appear on the display screen.
“Proceeding with this operation deletes all data stored in memory. Press [Action]
to proceed or [Record] to cancel.”