Casio EG-800 - Manual (Page 28)

28
• The time required to attain a full charge is greatly affected by ambient temperature
and the type of operations you perform on the CASSIOPEIA while charging is taking
place.
• You can normally operate the CASSIOPEIA while charging is taking place.
However, you will not be able to perform any operation when setting up the
CASSIOPEIA the first time after you purchased it, or while charging a new battery
pack for the first time.
Using a CompactFlash Card
Your CASSIOPEIA supports Type I and Type II CompactFlash cards (3.3V).
Important
• The card slot cover will not close when certain types of cards are in the slot. When
using such a card, detach the strap from the card slot cover, remove the card slot
cover from the CASSIOPEIA, and keep the cover in a safe place so you can replace it
when you remove the card.
• Gently but firmly slide the card into place as far as it will go, but do not force it.
Forcing a card can damage connectors. If you have problems inserting a card, pull it
out and check to make sure it is oriented correctly.
• We strongly recommend that you store all unsaved data you are inputting or editing
before performing this procedure.
• Sometimes, your CASSIOPEIA may not be able to detect a CompactFlash card. This is
indicated when a program on the card does not start up normally. When this happens,
remove the card, reinsert it, and then press the CASSIOPEIA RESET button.
• Your CASSIOPEIA supports 3.3V CompactFlash cards only. Cards that can operate
on 5.0V only are not supported.
1. Make sure your CASSIOPEIA is turned off.
• Press the [Power] button to turn off power.
2. Remove the stylus 1 and then remove the card cover 2.
1
2
Lift up on the slot on
this side of the cover,
and then remove it.