Casio 140CR - Manual (Page 11)

P
a
rt-1
11
E
Part-1 QUICK START OPERATION
3. Basic Programming for QUICK START Mode Switch
REG
OFF
RF
PGM
CAL X
Z
Procedure Purpose
1. Turn the mode switch to PGM position. Programming
2. When the display shows blinking “0”, such as
00-00-00
,
enter current date in Day, Month, Year order.
Example: 8, January, 2010: enter
?
• Enter 6-digit, last 2 digits for year set. (2010 → 10)
• If you have changed the date order (page-12), enter date of that order.
• By pressing
y, this procedure returns one by one.
Setting the
current date
3. When the display shows blinking “0”, such as
00-00
,
enter current time in Hour, Minute order.
Example: 1:18 PM, enter ZCZ<
• Enter 4-digit, use 24-hour system.
• By pressing y, this procedure returns one by one.
• If you want to adjust the date/ time, please refer to page 33 of this manual.
Setting the
current time
4. Input the desired add-in tax rate to the appropriate department key.
(This procedure below programs add-in tax rate only. If you want to set add-on tax or
tax with special rounding, refer to page 26 of this manual.)
A) Press the ~ key.
B) Enter tax rate. (Example: For 6% enter “6”, 5.75% enter “5.75”.)
C) Press the appropriate department key.
D) Repeat step B) and C) to set other department key.
E) Press the
k key to end tax programming.
Note: In case of setting the wrong tax rate to the key, please enter
?
and press
those department keys above, and quit this procedure by pressing
k key, and
start from the beginning of this procedure.
Setting the tax rates
Example :
Set add-in tax 8% to department 2, 3, 15% to department 4 key.
~ Start tax program.
8 S
Enter tax rate and press dept key.
8 D
Enter tax rate and press dept key.
15 F
Enter tax rate and press dept key.
k
To end the setting.