Auriol 101503-14-xx - Manual (Page 33)

33 GB/MT
described above) and take out the segment 7 .
Note: If you would like to take out more than one consecutive
segment 7 , it is sufficient to remove the two outer pins.
Connect the watch strap together again by joining the loose
segments 7 with a pin. Press this pin against the direction of the
arrow into the adjacent segments 7 .
Note: In order to remove one or more segments 7 directly on
the fastener 6 , press out the spring bar with the slider 9 ,
remove the fastener 6 and proceed as described above.
How to exchange the pin inside the slider
(Fig. F,G,H)
Take out the slider 9 , open the bottom cover 11 with the spare
pin 10 inside.
You will need the pliers to carefully remove the old pin from the
slider.
Insert the spare pin carefully into the slider by again using the
pliers. The new pin is installed.
101503_IT.indd 33 8/6/2014 11:45:42 AM