Auriol Z31311 - Manual (Page 32)

60 GB/MT 61 GB/MT
Activating / deactivating the
display illumination and
projection
You can activate the display illumination and the
projection by pressing a key, generating a noise
(e.g. a hand clap) or touching the device at any
place (acoustic and contact function).
Slide the S / C switch 25 to the ON position.
Activate the display illumination by pressing a key,
generating a noise or touching the device at any
place. The display illumination switches on for 5
seconds and then automatically switches off.
In addition, slide the projection switch 27 to the
ON position.
Activate the projection by pressing a key,
generating a noise or touching the device at any
place. The projection switches on for 20 seconds
and then automatically switches off.
Deactivate the projection by sliding the projection
switch
27 to the OFF position.
Deactivate the acoustic and contact function by
sliding the S / C switch
25 to the OFF position.
Adjusting the projection
sharpness, angle and direction
Rotate the projection objective 18 to the desired
projection direction (forwards / backwards) by
using the adjustment wheel
29 (see Fig. E).
Rotate the sharpness control wheel 19 to adjust
the projection sharpness.
Press the projection direction button 20 to turn the
projection direction through 180°.
Display temperature in °C / °F
The current interior temperature will be displayed in
the LC display.
Press the - / C / F / RCC key 24 to switch back
and forth between the Celsius and Fahrenheit
temperature scale settings
11 .
Setting the time zones
During stays in countries in which a DCF radio signal
can be received but are located in other time zones,
the corresponding time tone can be established.
For example, in a country in which the local time is
one hour behind Central European Time (CET), you
may set the 2nd time zone to -01. The clock time
continues to be controlled through the DCF radio
signal, but indicates an hour earlier.
Press the + / 12 / 24 key 23 until the symbol F for
the 2nd time zone appears on the LC display.
Press the SET key 21 and hold for about 2
seconds. The “00” hour display flashes.
Press the + / 12 / 24 key 23 or the - / C / F /RCC
key 24 to set the desired value.
Press the SET key 21 to confirm your entry.
To return from the 2nd time zone to the normal
time display
1 , press the + / 12 / 24 key 23 and
hold for about 2 seconds. The F symbol goes out.
Displaying summer time
The summer time is automatically displayed in the LC
display by the summer time symbol
5 .
78346_silv_Projektions-Funkwecker_Content_LB5_02.indd 60-61 8/9/12 2:43 PM