Auriol Z30398 - Manual (Page 71)

71 GB/MT
Putting the weather station into operation / Operation
Reception of the DCF radio signal can be stopped and restarted by pressing and holding
down the – / °C / °F / WAVE button
17 . If reception fails, change the location of the weather
station and try again to receive the radio signal.
Q
Operation
Reception of the DCF radio signal may be disrupted or interrupted at the location of the
weather station. In this case you are able to set the instrument manually.
Q
Setting the time / date manually
1. Press and hold down the – / °C / °F / WAVE button 17 approx. 2 seconds in order to
stop reception of the DCF radio signal (see Figure B).
2. Press and hold down the SET button 14 in order to change to the settings mode. The
time 1 flashes. In order to select the 24 or 12-hour format, press the + / MEM button 16
or the - / ° C / ° F / WAVE button 17 .
3. Press the SET button 14 to confirm what you have entered.
4. Repeat steps 2 and 3 in order to set the values for the year, date (day and month) 4 ,
current day 9 (in EN or DE), hours, minutes and time zone. If you do not press any
button approx. 15 - 20 seconds, the weather station will automatically exit the settings
mode.
note: If you are in a country in which the DCF signal is still being received, but where
the current time differs, you can use the time zone setting function to adjust the clock to
the current time.