Electrolux LAVAMAT 84745 - Manual (Page 37)

Operating Instructions
37
The washing is not suf-
ficiently spun. Water is
left in the drum.
Error code
(2
appears
.
Drain hose is kinked. Remove the kink.
Maximum pump height
(emptying height 1m from
base surface of the appli-
ance) is exceeded.
Contact your local Service
Force Centre. For pumping
heights over 1 m a conver-
sion kit is available as a spe-
cial accessory.
Drain pump is blocked.
Switch off appliance and pull
out the mains plug. Clean
the drain pump.
At the siphon connection: Si-
phon is blocked.
Clean siphon.
The door cannot be
opened when appliance
is switched on.
The door is locked for safety
reasons (the DOOR indicator
lights red).
Wait until the DOOR indica-
tor lights up green.
Should it nevertheless be
necessary to open the main
door:
Turn the programme knob to
OFF; turn the programme
knob to PUMP OUT. Press
button START/PAUSE. The
main door can be opened af-
ter the water has been
pumped out.
Power failure!
(All displays have gone off.)
For safety reasons the door
remains locked for 4 to 10
minutes.
If water can be seen through
the window in the door, first
carry out emergency empty-
ing (see section “Carrying out
Emergency Emptying Opera-
tion").
After approx. 4 to 10 minutes
the door can be opened
again by pulling the handle.
The programme security
function is On.
Cancel programme security
(see section „Programme
protection“).
Problem Possible cause Remedy