EVGA X58 3X SLI - Manual (Page 47)

Configuring the BIOS
Onboard Serial Port 1
This function on the Integrated Peripherals menu allows you to select the
onboard serial port 1 function. Options are [3F8/IRQ4], [2E8/IRQ3],
[3E8/IRQ4], [Auto], and [Disabled]
OnChip PATA/SATA Device
Press Enter to display the OnChip PATA/SATA Device menu.
SATA Mode
This is allows you set the onboard Serial SATA mode.
IDE: Use the Serial ATA hard disk drivers as Parallel ATA storage devices.
RAID: Create a RAID 0, 1, 0+1, 5 and JBOD configuration
AHCI: Use the AHCI (Advanced Host Controller Interface) to enables
advanced SATA features for improved performance with NCQ and
Hot-plug features
LEGACY Mode Support
This function allows the SATA controller to operate in LEGACY mode.
Selected Disabled if you install operating system that support Native mode.
JMB362 SATA Controller
This function allows you to enable JMB362 SATA Controller for SATA port
6/7 control. The options are Auto, Enabled and Disabled.
JMB363 SATA/PATA Controller
This function allows you to enable JMB363 SATA Controller for IDE &
SATA port control. The options are Auto, Enabled and Disabled.
JM363 Mode
This function allows you set the onboard Serial JM363 mode. The options are
IDE, RAID and AHCI.
AHCI Configurations [Press Enter]
SATA Mode [IDE]
LEGACY Mode Support [Disabled]
JMB362 SATA Controller [Auto]
JMB363 SATA/PATA Controller [Auto]
JMB363 Mode [IDE]