Curtis RCD869 - Manual (Page 9)

7
Setting the Clock
The clock can be set by using the buttons
on the front of the unit or the remote control.
Setting the Clock using the Unit
Controls
1. Press STANDBY on the unit so that the
display on the unit dims and the clock is
displayed.
2. Press and hold the PROG./MEMORY
button. The display will show either
‘24H’ or ‘12H’ .
3. Release the PROG./MEMORY button
and use either of the SKIP buttons to
select the clock mode you require,
either 12 or 24 hour clock.
4. Press the PROG./MEMORY button. The
display will show the time with the
hours flashing on and off.
5. Use either of the SKIP buttons to select
the hour and press PROG./MEMORY,
the hour stops flashing and the minutes
start flashing. Note that for the 12 hour
clock mode AM and PM are displayed.
6. Use either of the SKIP buttons to select
the minutes and press the PROG./
MEMORY button.
The clock is now set.
Setting the Clock using the Remote
Control
1. Press STANDBY on the remote control
so that the display on the unit dims and
the clock is displayed.
2. Press and hold the PROG./MEMORY
button. The display will change to flash
either ‘24H’ or ‘12H’.
3. Release the PROG./MEMORY button
and use the TRACK/TUNE buttons to
select the clock mode you require.
4. Press the PROG./MEMORY button. The
display will show the time with the
hours flashing on and off.
5. Use the TRACK/TUNE buttons to select
the hour and press the PROG./MEMORY
button The hour ceases to flash and the
minutes start flashing.
6. Use the TRACK/TUNE buttons to select
the minutes and press the PROG./
MEMORY button.
The clock is now set.