Curtis RCD869 - Manual (Page 10)

8
Operation
Now your CD micro system is installed and
ready for use, please refer to the following
instructions for correct operation.
AC Power Operation
The CD micro system will be in standby mode,
when the AC power supply is connected
and switched on.
At the front of the CD micro system, or using
the remote control, press STANDBY, to
switch the CD micro system on. The LCD
display will light up.
Volume Control
WARNING
Do not turn off the CD micro system
when the volume is set at high level.
When it is subsequently turned on, a
sudden blast of sound may damage your
hearing and the external speakers.
The volume level can be adjusted either
using the controls on the unit or by the
remote control.
On the unit turn the volume control towards
the ‘+’ sign to increase the volume and
towards the ‘-’ sign to reduce the volume.
The volume level will be displayed while
adjustments are being made.
Note: The volume control on the unit does
not fully rotate, you only need to turn
the control until it clicks.
To adjust the volume level using the remote
control, press the VOLUME +/- buttons.
Press MUTE on either the unit or the remote
control to mute the sound. Press MUTE again
to resume sound.
Note: Pressing any of the volume control
buttons will also resume sound.
Headphones
Note: Reduce the volume to a low level
before putting on headphones.
Adjust volume to a comfortable level.
A headphones socket is provided for private
listening. It is located on the front of the unit
.
see page 3
A pair of stereo headphones with a 3.5mm
stereo plug is required. Insert the stereo plug
into the socket for headphone use.
The external speakers are automatically
disconnected when headphones are in use.
BBS
Your CD micro system has "X-BASS"
sound effect setting. The setting can be
selected by pressing the BBS button on the
remote control or BBS button on the unit.
The setting appear at the top of the display
window.