Curtis RCD869 - Manual (Page 8)

6
Remote Control
The remote control requires 1 x 3V Lithium
Battery,
(CR2025).
Battery Installation
1. Press the small clip down a little as
shown in the first picture then slide the
battery holder out and remove.
2. Refer to polarity (+ or -) markings on
the battery holder and insert a new
battery.
3. Replace the battery holder
Note: The remote control will cease to
function when the battery becomes
weak.
Operating the remote control
Point the remote control at the front of the
CD micro system, to operate. The IR sensor
is located below the LCD display.
The remote control will work up to 7m away
from the IR sensor.
Do not block the path of the beam from the
remote control to the unit. Dark walls, direct
sunlight or very bright light will reduce the
sensitivity of the IR sensor.